Scrub drying, single work step (direct method)

Removing stubborn dirt from floor coverings in a single work step using the scrubber-dryer. Suitable for water-resistant, non-textile floor coverings.

Preparatory work

Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.
Check, equip and ready the machine and all accessories in compliance with the instructions for use.
Fill the fresh water tank with cleaning product solution in accordance with the dosing instructions. For machines with an integrated dosing system, fill cold water into the fresh water tank and refill the cleaning product as needed.
Put up the warning sign.
Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).
Wet mop any areas (e.g. corners) that cannot be reached with the machine.

Main task

Switch on the machine and lower the suction nozzle.
Use the machine with suitable pads or brushes to scrub-dry the open area in overlapping passes.
Perform a visual check.

Final steps

Remove the warning sign.

Empty the waste water and the fresh water tank, rinse them and leave them open to dry.

Rinse the pads, brushes and the suction nozzle with water.

Replace the pads, brushes and suction lips as needed.

Check the battery level and recharge as needed.

Dispose of any waste.

Clean the cleaning equipment and replace as needed.

Comments

  • Wear the personal protective equipment (PPE) required by company regulations, safety data sheets and / or instructions for use.
  • Always check in advance which product meets your requirements (see Wetrok Cleaning & Care Instructions).
  • Wetrok AG accepts no liability for damage caused by improper use or incorrect product selection.

You can use these products

Find out more

50334 DUOMATIC INTENSE DOSING 50
51459 PAD - DRIVE DISC 25
11000 ANTIWAX FORTE 10 L CNT
11620 ECOFLOOR 10 L CONTAINER
52613 SCRUB PAD RED 25
51192 SCRUBBING BRUSH FILAMENT 25

These methods may also be of interest to you

Sprocesscrub drying, two-step

Removing highly stubborn soiling from floor coverings in two work steps using the scrubber-dryer. Suitable for water-resistant, non-textile floor coverings.

Spray cleaning

Removing highly stubborn soiling from floor coverings using the single-brush machine with a scrubbing pad across the entire area. Use the spray application product to restore worn areas.

Polishing / Polish vacuuming (HS and US)

Polishing, equalising and condensing of waxed, coated or oiled floor coverings with the polishing pad or the polishing brush using the single-brush machine HS or US.

Hello! I am Ben

Find the right method with me: