Preparatory work
Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.
Check, equip and ready the machine and all accessories in compliance with the instructions for use.
Mount the suction unit and the suction ring on the single-brush machine.
Put up the warning sign.
Cover vulnerable areas (e.g. skirting boards) as needed.
Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).
Main task
Start by dry sanding along the edges.
Attach the sanding equipment with the LS pad drive disc to the LS single-brush machine.
Adjust the upright handle to the right length.
Switch on the machine. The connection must audibly click into place.
Dry sand the floor using the LS single-brush machine and the sanding equipment in slightly overlapping passes; after 2-3 passes, cross-sand the finished passes (painter method).
Reverse or replace the sanding equipment when it gets dirty; continue with step 2 of the main task until the entire area is sanded.
Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).
Perform a visual check.
Final steps
Check the fill level of the filter bag on the suction unit; change the bag if it is full.
Check the power cable for visible damage, clean the cable and roll it up loosely towards the plug.
Remove the covering material.
Remove the warning sign.
Dry vacuum the used sanding equipment or dispose of it as needed.
Dispose of any waste.
Clean the cleaning equipment and replace as needed.
Comments