Select suitable products to match the surface to be protected (type / square metres).

Put up the warning sign.

Completely remove stubborn dirt, care products and protective treatments with the suitable cleaning method as needed (e.g. wet scrubbing and wet vacuuming).

Den Bodenbelag vollständig trocknen lassen.

Allow the floor covering to dry completely.

Check the absorbency of the floor covering: Perform a water test.

Main task for strongly absorbent floor coverings

Pour a little bit of undiluted sealing agent onto the floor and use the application tool with the cover to apply it evenly, moving in slightly overlapping passes (circular motion). Leave to soak, distribute any excess sealing agent. Work backwards towards the exit.

To apply additional passes, pour a little sealing agent onto the wet area and spread it as described above. Repeat this step until the entire area has been treated.

Always lift up the application tool from the floor like "an airplane taking off” at the end.

Allow the floor covering to dry completely.

Check whether the protective treatment is sufficient: Perform a water test. Repeat the protective treatment as needed.

Perform a visual check.

Main tasku for slightly absorbent floor coverings

Spray a little of the undiluted sealing agent onto the dry floor covering and, performing overlapping passes, immediately spread it and massage it in using the LS single-brush machine and the red scrubbing pad (full-spray spray cleaning method). Repeat this step until the entire area has been sealed. Work backwards towards the exit. Continue with step 4 of the main task for highly absorbent floor coverings.