Preparatory work
Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.
Check, equip and ready the machine and all accessories in compliance with the instructions for use.
Fill the spray cleaning product into the spray unit in accordance with the dosing instructions.
Close the spray unit and build up pressure (pumping). Position the spray nozzle correctly.
Put up the warning sign.
Remove any loose dirt (dust-binding mopping).
Main task
Clean the corners and edges with the white pad either manually or with the edge cleaning tool.
Attach the scrubbing pad with the pad drive disc to the single-brush machine.
Set the correct height for the upright handle.
Switch on the machine. The connection must audibly click into place.
Apply little spray cleaning product section by section onto 2-3 passes from left to right and return with the LS single-brush machine and the scrubbing pad on each pass (without spraying), while immediately dry scrubbing the area in a circular motion until the dirt is picked up by the pad.
Reverse or replace the pad when it gets dirty; continue with step 5 of the main task until the entire area is clean.
Polish the entire cleaned area.
Perform a visual check.
Final steps
Clean the spray unit in accordance with the instructions for use.
Check the power cable for visible damage, clean the cable and roll it up loosely towards the plug.
Remove the warning sign.
Rinse the used pads or wash them in the washing machine.
Dispose of any waste.
Clean the cleaning equipment and replace as needed.
Comments