Wet mopping – two-step process (indirect method) with wringer

Removing more stubborn dirt using the lightly wrung-out cleaning cloth and the wet mopping unit from floor coverings in two work steps. Suitable for water-resistant, non-textile floor coverings.

Preparatory work

Select suitable products to match the surface to be cleaned (type / square metres) and the type of soiling.
Put up the warning sign.
Fill the blue fresh water bucket with cleaning product in accordance with the dosing instructions (max. 2/3). Fill the green waste water bucket with water (max. 1∕3) and mount the mop wringer on top.
Attach the mop correctly to the wet mopping unit.
Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).

Main task

First work step:

Immerse the mop fully in the cleaning solution (blue bucket) and wring it slightly.
Start along the edges of the room and under furniture, then use the wet mop and the wet mopping unit to mop the open space in slightly overlapping passes.
Immerse the mop in fresh water and wring it slightly as needed, then continue with step 1 of the main task (first work step) until the area to be cleaned is moistened completely.
Allow the cleaning solution to take effect, but don't let it dry.

Second work step:

Use the rinsed and thoroughly wrung-out mop to remove the dissolved dirt and the remaining cleaning solution.
Rinse the dirty mop if it gets dirty, wring it out well, then continue with step 1 of the main task (second work step).
Change the water and cleaning solution as needed; continue with step 1 of the main task (second work step) until the entire area is clean.
Perform a visual check.

Final steps

Remove the warning sign once the floor covering is dry.

Wash the used mop in the washing machine.

Dispose of any waste.

Clean the cleaning equipment and replace as needed.

Comments

  • Wear the personal protective equipment (PPE) required by company regulations, safety data sheets and / or instructions for use.
  • Always check in advance which product meets your requirements (see Wetrok Cleaning & Care Instructions).
  • Wetrok AG accepts no liability for damage caused by improper use or incorrect product selection.

You can use these products

Find out more

These methods may also interest you

Scrub drying – single work step

Removing more stubborn dirt using the lightly wrung-out cleaning cloth and the wet mopping unit from floor coverings in two work steps. Suitable for water-resistant, non-textile floor coverings.

Sprocesscrub drying, two-step

Removing highly stubborn soiling from floor coverings in two work steps using the scrubber-dryer. Suitable for water-resistant, non-textile floor coverings.

Spray cleaning

Removing highly stubborn soiling from floor coverings using the single-brush machine with a scrubbing pad across the entire area. Use the spray application product to restore worn areas.

Hello! I am Ben

Find the right method with me: